ok so @timonskuTimon ๐Ÿ›  visited and soldered his custom multitouch trackpad design for the MNT Reform Next. and it works! i just had to bring my windows 10 VM up to date to run azoteq's config/debug GUI which you can see here, and figure out the correct rx/tx col/row mappings. next step will be integrating the new chip in our open source firmware.

0

If you have a fediverse account, you can quote this note from your own instance. Search https://mastodon.social/users/mntmn/statuses/114157061096017158 on your instance and quote it. (Note that quoting is not supported in Mastodon.)